[Tut] How To Make A 3D Text Signature [Tut]

[Roro]

Hello guys, today I will be showing you how to make a simple 3D signature in Photoshop CS4.

Examples:

Spoiler (Click to View)

Spoiler (Click to View)

Here we go.

Step one:
Make a document, between 300x100 to 400x150 (I usually use 380x120)

Spoiler (Click to View)

Step Two:
Next thing you want to do is pick a font type you text, make sure you place the text exactly where you want it to be.

Spoiler (Click to View)

Step Three:
Now press "V" on your keyboard to change to the move tool, then what you want do is hold Alt and alternate between two arrows, for ex: up,left,up,left or down,right,down,right until you have copied the layer about 10-15 times.

Spoiler (Click to View)

Step Four:
Ok, now we're going to merge all the layer together except one of them. To do this hold Ctrl and click on all the layers, after you have them all highlighted right click and choose Rasterize Type, after that right click again and choose Merge Layers.

Spoiler (Click to View)

Step Five:
Next thing we're going to do is move the only layer that isn't rasterized to the top and right click on it, then press blending options. When the screen pops up, choose what pattern you want and put a Bevel and Emboss. One more thing you're going to do is put a Bevel and Emboss to the settings I will show you. So here is what I did:

Spoiler (Click to View)

Step Six:
Now, for the color, just highlight the text and change it how you would normally change the color for text.

Note: If you want to change the color for the copied layers, go to blending options and change the color overlay. Also, make sure to save the picture as PNG, to keep the transparency.

Here's what I finished with.